Laboratory & Test`s
     
Dezember 2006:  Biogas Johann Hochreiter aus Schnaitsee nutzt und empfiehlt METAL LUBE auch den Kunden. Biogas Hochreiter hat ML in seinen eigenen Biogasanlagen und Rührwerken getestet.  Schnell- und Härtetest`s wurden durchgeführt. In den Motoren und in den Getrieben wurden dabei beste Ergebnisse erziehlt.
   
June 2006: Langstreckenrennen in Hockenheim,  das PT-Race Team von J.Hechfellner und Josef Sattler (O-Ton/ Zitat J. Hechfellner:  wir hatten sehr sehr starke Hitze Probleme.  Kühler zu 120 Grad,  jeder Motor währe defekt gewesen,  dank METAL LUBE hatten wir keiner leih schaden am Motor).
   
März 2006: Josef Sattler auf dem Motorprüfstand für das Sidecar Team . Das Methanol ist jetzt beständig mit dem Öl. Das 1. Prüfprotokoll zeigt 1 ps mehr Leistung!
   
Dezember 2005:  SRV Test durch " Blaser SWISS Lube AG" positiv durchgeführt.
   
September 2005:  Die Wilga, der Falke Mose & die CRI CRI von H.Lehner machen 100RPM mehr! Cessna`s , Piper, Bechcraft, Flugzeuge der General Aviation nutzen MetalLube.

---

    
ASTM USA - American Society for Testing and Materials
  
Various independent laboratories have tested the principal components of the METALLUBE products. The following are the tests that were done according to ASTM standards:
  
D2783 -mesurement of extreme pressure properties of lubricating fluids, four ball method.*
D4172 -wear provenitve charactieristics of lubricating fluids, four ball method.** *
  
Results: the principal component that is used in the METALLUBE products was able to withstand extreme pressures with a marked minimum of wear. **After one hour, the scar suffered by the balls with the lubricant alone was sustantially greater than the test performed with the principal component that is used in the METALLUBE products.

---

  
INTA - Spain National Institute of Aerospace Technologie  
   
The National Institute of Aerospace Technology in Madrid, Spain, tested two samples of a 15W50 motor oil. The first test was performed on the 15W50 motor oil alone. The second test was performed with the same oil plus 6% of METAL LUBE added. The following are the tests that were performed:
      D2266 -wear preventive characteristics of lubricating grease four ball method. In this test a steel ball turns at 1200 r.p.m on top of three stationary steel balls with a load of 40 kg. 75° C for one hour.
      Results: after one hour, the scar suffered by the balls with the lubricant alone was 30% greater than the stest performed with METALLUBE. D2783 -measurement of extreme pressure propeties of lubricating fluids, four ball method.
   

Test:		15W50 oil		15W50 oil + 6% MetalLube
Hertz half load		41 kg		72 kg
Last load before seizing		100 kg		126 kg
Weld point		200 kg		500 kg

Results: the above test showed that oil with METAL LUBE was able to withstand higher extreme pressures than with the oil alone. 

---

   
Colombia - Mecanizados Motores S.A. 
     The laboratory of "Mecanizados Motores S. A." of Colombia tested two samples of a 20W40 motor oil. The first test was done on the motor oil alone. The second test was done with the same oil plus 3 % of METALLUBE added. The following are the tests that were performed Norma 03-80-600/ A. Renault, exteme pressure and anti ewar test.
   
Observations: comparative analysis on the Royal Dutch/Shell 4 ball machine. In this test a steel ball turns at 1200 r.p.m. on top of three starionary steel balls with a load of 40 kg. @ 75°C for one hour.      
      
Results: after one hour, the scar suffered by the balls with the lubricant alone was 30% greater than the test performed with METALLUBE.